Honda Prelude 1993 Service Manual page 834

lnstallation
28. Connect the lowe. arm, lower arm B (2WSl or tie-
rod end (4WS) 8nd upper arm with the knuckle, then
tighten the castle nuts,
29. Install the naw cotter oins.
30. Install the knuckle Drotector with the bolt.
31. Connect the knuckle and the stabilizer bar, then
tighten the new selflocking nut.
CASTLE NUT
1 0 x 1 . 2 5 m m
40-/t8 N.m 14.0-4.8 kg-ir,
29 - 35 tb-tr)
COTTER PIT{
On roa$ombly,
bond th€ cott€r pin
SELF.LOCKING I{UT
1 2 x 1 . 2 5 m m
55
.m 15.5 ks-m,40 lb-ttl
CASTLE ITUT
14 x 2.0 mm
50-60 N.m (5.0-6.0 kg-m,
36-43 tb-ft|
COTTER PIN
CASTLE NUT
1 2 x 1 . 2 5 m m
50-60
.m (5.0_6.0 kg.h,
36_43 tb-ttt
32. Install the rear spindle assembly on the knuckle, then
tighten the new self-locking nuts.
SEI.F.LOq(NG IIUTS
lO r 1.25 mm
45 N.m (4.5 kg{n, 33 lb-ftl
1 8 - 3 1
33. Install the whe€l sensor, wheel sensor wire bracket
and parking brake cable on the knuckle.
NOTE: Be careful when installing the sensor to avoid
twisting the wire.
34. Install the splash guard with the bolts.
22
.m {2.2 kg-m, 16lb-ftl
22 N.m 12.2 kg-m, 16 lb-ft)
10 N.m (1.0 kg{, 7 |tsft}