Clutch Pedal; Adjustment - Honda Prelude 1993 Service Manual

Glutch Pedal
Adjustment
NOTE
. To check the clutch pedal switch A and B, see section
. The clutch is self-adjusting to compensate for wear.
CAUTION: ll th€ro is no cl6aranc6 betwo€n tho mastel
qylindor piston and push rod, the release bearing is held
lgainrt tho diaphrrgm spring, which can result in clutch
slippago or other clutch probl€ms.
1 , L o o s e n l o c k n u t A , a n d b a c k o f f t h e c l u t c h p e d a l
switch A or bolt until it no longer touches the clutch
peoal.
2.
Loosen locknut C, and turn the push rod in or out to
g e t t h e s p e c i f i e d s t r o k e a n d h e i g h t a t t h e c l u t c h
D e o a t .
3. Tighten locknut C,
Thread the clutch pedal switch A in until it contacts
the clutch pedal.
Turn the clutch switch A in 114 - '12lurn further.
Tighten locknut A.
Loosen locknut B and clutch pedal switch B.
Measurs the clsarance between the floor board and
clutch pedal.lvith the clutch pedal fully depressed,
Release the clutch pedal '15 - 20 mm (0.59 - 0.79
i n ) f r o m t h e f u l l y d e p r e s s e d p o s i t i o n a n d h o l d i t
there.
Adjust the position of clutch pedal switch B so that
the engine will start with the clutch pedal in this
position.
7 .
8 .
q
10. Thread the clutch pedal switch B in 114 -
112-tu'n
further,
LOCKNUT C
11. Tighten locknut B.
LOCKNUT B
10 N.m {1.0 kg-m, 7 lb.ftl
15 N.m 11.5 tl tb-ft}
CLUTCH PEDAL SWITCH B
CLUTCII PEDAL SwlTCH A
PUSH ROD
L(rcKNUT A
10 l,I.|n (1.0 kg.m, 7 lb.ft)
CLUTCH MASTER CYLINOER
Padrl in contld whh awhch
SPRING
@ (STROKE 8t PEDALI: 135 - 1ir5 mm (5.31 - 5.71 in)
@ (TOTAL CLUTCH PEDAL FREE PLAY): 9.0 - 15.0 mm 10.35 - 0.59 in) includo ths psdal plsy 1 - 7 mm t0.0t - 0.28 in).
@ ICLUTCH PEDAL HEIGHT): 190 mm (7.48 in)
@ ICLUTCH PEDAL DISENGAGEMENT HEIGHT): 9,[ mm (3.70 in) minimum to the ftoor.
CLUTCH ASSIST
-6El
2-4