Honda Prelude 1993 Service Manual page 228

12. Ch€ck the housing-to-outer rotor radial clearance,
Housing.to-Outer Rolor Radial Clrarsnc€
Stlnda.d {Nsw}: 0.10 - 0.19 mm (0.004 - 0.007 in}
Sorvica Limit:
0.21 mm (0.fi)8 in)
-
l f t h e h o u s i n g - t o - o u t e r r o t o r r a d i a l c l e a r a n c e
exceeds the service limit, replace the set of inner
and outer roto.s and/or the pump housing.
Inspect both rotors and the pump housing for scor-
ing or other damage. Replace parts if necessary.
Remove the old oil seals from the oil pump.
Gently tap in the new oil seals until the special tool
bottoms on the pump.
NOTE: The oil seals alon€ can be reolaced without
romoving th€ oil pump using the specialtool.
1 3 .
t 5 .
1 7 .
, r J : | x a T m m
077a6 _ 00,t0300
Rsassemble the oil pump, applying liquid thrcad
lock to the pump housing screws.
Check that the oil pump turns freely,
?8. Install a dowel pin and the new O-ring on the pump,
NOTE:
Use liquid gasket, Pan No. 08718 - 0001.
Check that the mating surfaces are clean and dry
before applying liquid gasket.
Apply liquid gasket evenly, in a narrow bead cen-
tered on the mating surface.
a
a
. To prevent leakage of oil, apply liquid gasket to
the inner threads of the bolt holes,
. Do not install the parts if 20 minutes or more
have elapsed since applying liquid gasket.
Instead reapply liquid gasket after removing the
old residue.
. After assembly, wait at least 30 minutes before
filling the engine with oil.
19. Apply liquid gasket to the oit pump and insta it.
. Apply grease to the lips of the crankshaft oil seal
and the balancer shaft seal. Then, install the oil
pump Inner rotor onto the crankshaft. When the
pump is in place, clean any excess grease off the
crankshaft and the balancer shaft, then check
that the oil seal liDs are not distorted.
Apply iiquid gasket
along the broken line.
(cont'd)
8 - 1 1