Honda Prelude 1993 Service Manual page 211

NOTE:
.
Use liquid gasket, parr No.087t8-0001.
. Check that the mating surfaces are clean and dry
before applying liquid gasket.
. Apply liquid gasket evenly, being careful to cover
allthe mating surface.
. To prevent leakag€ of oil. apply liquid gasket to
the inner thr6ads of th6 bolt holes,
. Do not install the parts if 20 minutes or more
have elapsed since applying the liquid gasket.
Instead reapply liquid gasket after removing the
old residue,
. After assembly, wait at least 30 minutes before
filling th6 engine with oit.
8.
Apply liquid gasket to the block mating surfaee of
the right side cover, then install it on the cylinder
block.
BIGHT SIDE COVER:
Apply liquid gaskst along
the broken line.
Apply liquid gasket
to block mating surface.
6 x 1,0 rnm
12 N.m (1.2 kg'm, 9 lb-ft)
Apply liquid gasket
to the bolt threads.
RIGHT SIDE COVER
9. Apply liquid gaskst to the oil pump mating surfac€
of the block, then install the oil pump on the cylin-
der block.
. Apply grease to the lips of the oil seals.
T h e n , i n s t a l l t h e o i l p u m p w h i t e a l i g n i n g t h e
inner rotor with the crankshaft. When the pump
i s i n p l a c e , c l e a n a n y e x c e s s g r e a s e o f f t h e
crankshaft and the balancer shaft, then check
that the oil se8l lips are not distorted.
OIL PUMP:
{cont'd)
7 -27