Honda Prelude 1993 Service Manual page 955

Rear Window
Installation (cont'd)
4.
Gbo rha rubber dams to the inside lsce of ths roar
window as ahown, to contain th€ adhssive during
instalrtion.
NOTE:
Bs careful not to touch the roar window wh€ra
sdh6sive will b6 sDoli€d.
Glu6 th€ side and uppar tasteners to the insid6 fsce oJ
r6ar window as shown.
BUBBER DAM
ALIGNMENT MARKS
UPPER FASTEI{ER (2}
RUBBER DAM
SIDE FASTENER (2}
REAB WINDOW
FAETENER
REAR WII{DOW
10 lnm (039 Inl
H
Nft
. - I
I
FASTENER {4)
6. Installth€ glass brack€ts and fasten€rs to the body 8s
snown,
NOTE:
Do not tighten the glsss brscket mounting 8crews.
GLA88 BRACKETS {2}
7.
Set the rear window upright on the ghss brsckots,
than cent€r it in the opening. Make alignrnont marks
acroaa the roar window 8nd body with E grease p€ncil
at the tour ooints shown.
NOTE:
Adiust ths brsck€ts to center the rsar window in the
opening, then tighten th€ mounting screws.
ALIGNMEIfT MARKS
20-22