Honda Prelude 1993 Service Manual page 782

Steering Gearbox
lnstallation (cont'd)
18. Reconnect the tie-rod ends to the steering
knuckles. tighten the castle nut to the specified tor-
que, and instail new cotter pins.
CAUTION: Torque the castle nut to the lower tol-
qu€ sp6citication, th6n tighton it onlY tar €nough to
atign the slot wilh the pin hol6. Do not align the nut
by loosening.
CASTLE NUT
50-60 N.m
(5.0-6.O kg-m.
36-/13lb-ft)
COTTER PIN
On reassembly, bond
the cottgr pin as shown.
'19.
Adiust the front toe (see section 18).
NOTE: lf the steering wheel and rack are notalign-
ed centered, reDosition the serrations at lower end
of the steering joint.
20. Fill the system:
a Fill the reservoir with new Honda Power Steer-
i n g F l u i d - V { s e e p a g e 1 7 - 7 7 ) .
21. After installation, perform the following ch€cks
a Stan the engine and let it run at idle, then turn
the steering wheel trom lock-to-lock several
times to bleed air from the system (see page
1 7 - 7 7 t .
a Check the fluid again, and add more if
necessary.
a Check the gearbox for leaks.
a Check the tront toe (see section 181.
a Check the steering wheel spoke angle.
a Check the 4WS system {4WS only).
16. Automatic transmission model only.
a Connect the shift cable end to the shift control
shaft. and install the cable holder.
CABLE
1 8 N ' m
1 1 . 8 k g - m , 1 3 l b ' f t |
17. Install the exhaust pipe A with a new gasket. then
tighten the new self-locking nuts. Connect the
heated oxygen sensor connector (H23A1 and
H 2 2 A 1 e n g i n e ) .
55 N.m 15.5 kg-m,40 lb-ftl
EXHAUST PIPE A
SHIFT CABLE
tl.4 kg-ln, 10 lb-ftl
7 -1
36