Honda Prelude 1993 Service Manual page 639

Driveshafts
Reassembly lcont'd)
8.
Pack the inboard ioint with the ioint grease included
in the new driveshaft set.
Groaso Ouantity: 130-140 g (4.6-4.9 oz)
A/T mod€ls, Laft ddveshaft
120- 130 g 14.2-4.6 ozl
9.
Fit the inboard ioint onto the driveshaft.
CAUTION: To provant it from falling oft, hold tho
drivoshaft assomblY so tho inboard joint points up.
INBOARD JOINT
HOLOER
Adjust the length of the driveshafts to the tigure
below. then adjust the boots to halfway between
full compression and Iull extension.
NOTE: The ends oJ boots seat in the groove of the
driveshaft and joint.
R i g h r : 5 0 7 . 9 - 5 1 2 . 9 m m ( 2 O . O O - 2 0 . 1 9 i n )
Left:
. A/T modelg
8 6 2 . 9 - 8 6 7 . 9 m m ( 3 3 . 9 7 - 3 4 . 1 7 i n l
. M/T models
52O.9- 525.9 mm (2O.50-20.7O inl
Manual Transmission OnlY:
Align the holder direction of the rollers
toward the slot of inboard joint as
1 0 .
t
1 6 - 8
1 1 .
1 2 .
lnstall new boot bands on the boot and bend both
sets ot locking tabs
Lightly tap on the doubled-over portions to reduce
their height.
1 3. Position the dynamic damper as shown below.
a Install a new dynamic damper band and bend
down both sets of locking tabs.
a Lightly tap on the doubled-over portion of the
band to reduce its height.
DAMPER BAND
DYNAMIC OAMPEB
175 r 2 mm 16.9 a O.l In)