Honda Prelude 1993 Service Manual page 794

4WS System Inspection
Electronic Neutral Check (cont'd)
8. Check the front sub steering angle sensor with the
ignition switch on {engine off),
- From the slraight ahead driving position. turn
the steering wheel to the right, then turn it slow-
ly to the left beyond the straight ahead driving
position. Do not turn the steering wheel
inversely.
- Turn the steering wheelto the right, then turn to
the left beyond the straight ahead driving posi-
tion. Repeat this operation several times until
you find the center point of the range where the
4WS indicator light blinks (at the intervals of O.2
seconds).
4WS INDICATOR LIGHT
The center point should be within the range of t55
mm l!2.2 ini 11 6,50 ) from the center mark on the
steering wheel. After adjusting the front sub steer-
ing angle sensor, however, the center point should
b e w i t h i n t h e r a n g e o f 1 1 8 m m ( 1 0 . 7 i n / 1 5 . 5 " )
from the center mark.
- It the center point is outside the marked range
on the steering wheel. adjust the front sub steer-
ing angle sensor (see page 17-1 53).
17-148
Rsal sgnsols insDection:
9. Release the parking brake lever fully to turn off the
parking brake indicator light. This sets the rear sen-
sors in the insDection mode.
Turn the ignition switch off.
Remove the cap bolt and sealing washer from the
rear steering actuator. and screw the special tool
into the rear steering actuator as far as it will go.
NOTE: Do not start the engine with the special
tool set in the rear steering actuator.
'I
O.
1 1 .