Honda Prelude 1993 Service Manual page 772

Steering Gearbox
Overhaul (cont'd)
29.7 x 1,9 mm
S[{AP RII{G
O-R|NG
\ t
\ l
\.-6
^@"\
* \ !
@'f
\
\
cYtlt{DER cAP
I
SEAL RETAINER
35. Slide the cvlinder cap onto the seal retainer.
36. Install the snap ring on the seal retainer and coat
new O-ring with power steering fluid and install it
on the seal reta,ner.
37. Grease the sliding surface of the rack bushing B.
and install the bushing on the steering rack.
-Gl
RACK BUSHING
17-126
38. Gr€ase the sliding surfaces ot the new cylinder end
seal and the specialtool. then place the seal on the
special tool with its grooved side facing opposite
the slider.
BACK.UP RING
Make sure the back-up
ring is seated in the
cylinde. end seal.
CYLINOER ENO SEAL
lnstall end soal with its grooved
side facing opPosite
seal slider.
CYLINDER END
SEAL SLIDER
07LAG-SM/tO30A
39, lnstall the special tool and cylinder end seal.