Honda Prelude 1993 Service Manual page 788

Rear Steering Actuator
Assembly (cont'd)
3.
Grease a new O-ring and install it in the .ear main
steering angl€ sensor, then install the rear main
steering angle sensor.
REAR MAIN STEERING
ANGLE SENSOR
TORXO EOLT
1O lt'm
{1.O ks-m, 7 lb-ttl
-611
o-Rrr{G
DOWEL PINS
Screw each rack end into the shaft screw while
holding the lock washer so lts tabs are in the slots
the shaft screw end.
NOTE: Install the stopDer washer with the
chamfered side tacing out.
STOPPER WASHER
o .
5 .
7 .
Using a soft hammer, drive the special tool be-
tween the housing and stopper washer with the
tlat side of the special tool toward the housing.
Tighton the rack end securely, then bend the lock
washer back against the tlat on the flange as
snown.
55 N.m
15.5 kg-m, rto lb-ftl
CAUTION:
a Tako exfiomo car6 not to apply axisl impact and
fotational tolc€ on the shaft screw.
a S€t th€ projoction ot the lock washer in the
groove in the lack securely. After tightoning the
rack ond, bend th6 tabs of ths washer sgainst
the tlats secur€ly.
Remove the special tool,
Apply grease to the circumference of the rack end
housing.
Coat the rack end groove and inside ot the boot
with silicone grease.
:-
GREASE
8 .
o
Coar the sliding
surtace of the rack
end.
BOOT
ACTUATOR HOUSING
17-142
TUBE CLAMP