Honda Prelude 1993 Service Manual page 543

6 .
Disconnect the glound cabsl from the transmission
and body.
Remove the bEttery base whh th€ ground cable.
Removs the battery bass stay.
GROUND CABLE
BATTERY BASE STAY
Disconnect the lock-up control solenoid valve and shift
control solenoid valve connectors.
Disconnect the throttle control cable from the throttle
controllever.
Disconnect the mainshaft speed sensor connector.
Remove ths ATF cooler hoses at the joint pipes.
Turn the ends of the ATF cooler hoses uo to Drevent
ATF from flowing out, then plug the ioint pipes.
NOTE:
Check for any signs of leakage at tha hose joints.
6 .
q
1 0 .
1 1 .
12.
MAI]TSHAFT SPEED
SE SOR COI{NECTOR
SOLENOID VALVE
coNf{EcToRs
TRANSMISSK)N
GROU D
CABLE
REAR STIFFENER
1 4 - 8 1
1 3 .
1 4 .
Remove the starter rnotor cables.
Disconnect the countershatt speed sensor connector.
COUNTERSHAFT SPEED
SENSOR CONNECTOR
STARTSER
MOTOR
15. Disconnect the vehicle speed sensor connecter.
Remove the rear stiffener, then remove the vehicle
speed sensor/power steering spaed sensor.
NOTE:
Do not disconnect the power steering pressure hoses
from the vehicls speed sensor/pow€r steering speed
s9nsor,
POWER STECRING
PRESSURE HOSES
REAR EI{GINE
MOUI{T
VEHICLE SPEED
SENSOR
POU'ER STEERIT{G
\
\SPEED
SENSOR
O-RING
Replac6.
(cont'dl