Honda Prelude 1993 Service Manual page 127

Rocker Arms/Camshafts and Seals/Pulleys
lnstallation (cont'd)
4.
Tighten the camshaft holders temporarily'
a Make sure that the rocker arms are properly posl-
tioned on the valve stems'
5. Press in the camshaft seals securely.
Tighten each bolt in two steps to ensure that the rock-
ers do not bind on the valves.
\
Specified Torque:
qceq@, O,
(9, (r,
lntake
1O N.m (1 .O kg'm, 7 lb-ft)
1 2 N.m (1 .2 kg-m, I lb-ft)
INTAKE
6-58
1 1 .
SDecifi6d Torque: Exhaust
Exceot G), (O:
10 N m {1.0 kg-m, 7lb-ft)
@ , @ i
1 2 N . m { 1 . 2 k s - m , 9 l b - f t )
8 .
lnstall the back cover.
Install keys into camshaft grooves.
NOTE: To set the camshafts at TDC position for No'
1 piston, align the holes in the cdnshafts with the
holes in llo. 1 camshaft holders and insert 5'O mm pin
punches in the holes.
9.
Push camshaft pulleys onto camshafts, then tighten
the retaining bolts to the torque specified'
Adjust the valve cle316nes (page 6-68).
After installation, check that the all tubes, hoses and
connectors are installed correctly.
1 0 .
I x 1 . 2 5 m m