Honda Prelude 1993 Service Manual page 778

Steering Gearbox
Overhaul {cont'd}
76. Coat the rack guide sliding surface with grease.
77. Install the rack guide, spring, O-ring and the .ack
guide screw/front sub steering angle sensor on the
gear housing. Then adjust the rack guide at the
center of the rack stroke.
LOCKNUT
RACK GUIDE SCREW
FRONT SUB STEERING ANGLE
SENSOR
78. Tighten the rack guide screw until it compresses
the spring and seats against the rack guide. then
loosen it.
79. Retighten it to 4 N.m (O.4 kg-m, 3lb-ft). back it otf
about 20
+
3' and install the locknut on the rack
guide screw with the special tool.
80, Tighten the locknut to with the special tool about
25 N.m (2.5 kg-m, 18 lb-tt) while holding the guide
screw.
O.RING
-6,1
RACK GUIOE
17-132
81 . Coat the 9.8 x 1 .9 mm O-rings with power steering
Jluid. and install them together with the orifices.
82. Coat the 45.5 x 2 mm O-ring and pinion holder pin
with grease, then install it in the valve body unit.
83. Install the valve body unit on the gear housing with
the two 8 mm bolts.
CAUTION:
a Whon installing. b€ carolul not to hit the pinion
holder pin.
a Make sute the O-rings ale in place and not
pinched.
8 mm BOLT
22 N.m
(2.2 kg-m, '16 lb-ftl
Ee?H",.
45,5 x 2 mm
O.RING
9 . 8 x 1 . 9 m m
O.RINGS