Honda Prelude 1993 Service Manual page 102

Hide thumbs Also See for Prelude 1993:

Table of Contents

Timing Belt and Timing Balancer Belt

Replacement (cont'dl

22. Make sure the crankshaft is positioned with the No 1

piston at TDC.

23. Align the groove on the front balancer after pulley with

the pointer on the oil pump housing as shown,

24. Align the rear balancer shaft pulley by using 6 x 1OO

mm bolt or equivalent as an alignment tool.

Scribe a line 74 mm (2.9 in) from the end ol the bolt.

Insertthe boh intothe maintenance holeto the scribed

Loosen the adjusting nut and verity that the timing

balancer belt adjuster moves freely.

Install the timing balancer belt. Remove the 6 x 1OO

mm bolt from the rear balancer shaft.

27. Turn the crankshaft pullev about one turn counter-

clockwise, then tighten the adjusting nuit to the speci-

{ied torque.

NOTE: Both belt adiusters are spring-loaded to

properly tension the behs. Do not spply any extm pres-

sure to the pulleys or tensioners while performing the

REAR BALANCER SHAFT

MAII{TENANCE

TIMING BALA'TCER BELT

DRIVE PULLEY

Set the crankshaft at TDC.

6 x 100 1'|m BOLT

12 mm SEAU G BOLT

30 N.m (3.0 kq-tn, 22 lb-ftl

NOTE: Tighten the bolt after

installing the belt.

AI'JUSTII{G NUT

Align the groove of the

front driven pulley with the

pointer on the oil pump housing.

74 mm 12.9 in)

6 x 10O mm BOLT

Troubleshooting