Honda Prelude 1993 Service Manual page 58

Engine Removal/lnstallation
@
frla-i6iwe
iacks and saletY stands 8re placod ploper-
ly and hoist brackots are attachod to the corr'ct
positions on th€ 6ngin6.
a Mako suls tho car will not roll ofl stands 6nd lall
whlle you are working undal it.
CAUTION:
a Use tend€l covers to svoid damaging paint€d
surtacas.
a Unspocified itoma alo common
a Unplug th€ wiring connoctolE carstullY while holding
the connoctor portion to avoid damago.
a Mark all wiring and hosas to avoid miaconnection.
Also. bo 3u1€ that thoy do not contact othar witing ol
hosos or into.ler€nco with othar parts.
NOTE: The radio may hsve a coded thett protection cir-
cuit. Be sure to get the customer's code numb€r belore
- Disconnecting the battery.
- Romoving the No. 43 (10 A) Juse (ln the under-hood
tuse/relav boxl.
- Removing the radio.
Atter service, reconnect power to the radio and turn at
o n .
When the word
"CODE" is displayed. enter the
customer's 5-digit code to restore radio operation.
1. Secure the hood as far open as possible.
2. Disconnect the battery negative terminal tirst, then
the positive tetminal.
3. Remove the radiator cap
!@
use care vuhon removing tho radiator
cap lo avoid scalding by hot coolant ol atoam.
4. Raise the hoist to full height.
Remove the Jront wheels and the engine splssh
shield.
1O N.ln (1.0 kg-m,
7 lb-ftl
6 x 1 . 0 m m
5. Loosen the drain plug on the radaator.
6. Drain the transmission oil/lluid. Reinstall the drain
plug using a new washer.
7 . Orain the engine oil. Reinstall the drain plug using a
new wasnef.
CAUTION: Do not ovsrtighlan tho dlain plug'
8. Lower the hoist.
9. Remove the air cleaner housing and intake air duct'
6 x 1.O ]||m
10 .m {1.0 ks-m, 8 lb-ftl
AIR CLEA'{EF HOUSI'{G
1O. Remove the pulsed secondary air iniection IPAIR)
vacuum tank and bracket.
PAIR
VACUUM TANK
6 x 1 . O m m
lO N.m 11.0 kg-m,
I rb-trl
6 x 1 . O m m
'10 t{.m (1.O kg-m,
a tb-ft|
BRACKET
I
Front
5 - 1 8