Honda Prelude 1993 Service Manual page 774

Steering Gearbox
44, Placs the gea. housing on the work bench and in-
sert the seal retainer and steering rack into the gear
housing.
45. Coat the inside surface of the cylinder with powet
steering fluid, slide it over the rack and into the gear
housing; press it into the housing untill il seats'
STEERING RACK
SEAL RETAIITER
HOUSING
Install the cylinder spring over the rack, then coat
the rack bushing A with grease and install it on the
sp.ing.
Wrap the end of the steering rack with vinyl tape.
Coat the tape with grease.
-6q
,6Q
RACK BUSHTNG A_e2
CYLINDER SPRING
Overhaul (cont'd)
STEERING RACK
46.
4 7 .
A)
-.9
d
--F\
Vinyl tape
-Gl
17-128
48. Coat the inside surface of the cylinder with power
steering fluid and install the cYlinder end seal with
its grooved side Jacing out.
GROOVES
CYLINDER END SEAL
49. Coat the new O-ring with grease. then installthe O-
ring and back-up ring into the gear housing.
50. Carefully position the cylinder on the gear housing
and loosely install with four cylinder bolts.
CAUTION: Bo cartul not to damage tho 6nd se€l in
the cylinder housing.
CYLINDER HOUSING
59 x 2.4 mm
E
CYLINDER
ENO SEAL
O.RING
-6ll