Honda Prelude 1993 Service Manual page 787

7 . Remove the rear sub steeting angle sensor from the
actuator housing.
REAR SUB STEERING
ANGLE SENSOR
Remove the rear main steering angle sensor from
the actuator housing.
CAUTION: Aftor disassembly, attach a pioco of
tape or equivalent materialon each port andioint ot
tho r6ar stooring actuator to protoct it trom dust.
dirt, and foraign matoriala.
Assembly
Install the locknut on the rear sub steering angle
sensor, then grease a new O-ring and install it.
Screw the rear sub steering angle sensor into the
actuator housing fully by hand, back it off about
1/2 turn, and loosely tighten the locknut.
1 .
REAR SUB STEERIITG
AI{GLE SENSOR
Screw in the resr sub stgering
angle sonsor until se6ted, thgn
back it oft about 1/2 turn.
8 .
LOCKl{UT
ACTUATOR HOUSII{G
NOTE: Adiust the rear sub steering angle sensor
(see page 1 7-1 55) after instslling the rear steering
actuator on the car.
{coltl c
LOCKNUT
ACTUATOR HOUSING
REAR MAIN STEERING
17-117