Honda Prelude 1993 Service Manual page 229

Oil Pump
12 N.m 11.2 kg-m, 9 lb-ft|
Apply liquid gasket to the
bolt threads.
6 x 1 . 0 m m
12 N.m (1.2 kg"m,
9 tb-ttl OIL SCREEN
2 1 .
Install the baffle plate.
Install the oil screen.
Apply molybdenum disultide to the thrust surfaces
of the balancer gears. as shown, before installing
t h e b a l a n c e r d r i v e n g e a r a n d t h e b a l a n c e r g e a r
BALANCER DBIVEN
GEAR
BALANCER DRIVE
GEAR
8-12
Removal/lnspection/lnstallation
{cont'd}
Apply grease
to the seal lips. 6 x 10 mm
OIL PUMP
Apply liquid gasket
to block mating surface.
O.RINGS
Apply engine oil.
Replace.
case.
Apply molybdonum
disulfide.
23, Hold the rear balaocor shaft with the 6 x 100 mm
bolt, then install the balancer driven gear.
REAR BALANCER:
I x 1.25 mm
25 N.m {2.5 kg-m, 18lb-ft}
24. Hold the front balancer shaft with a screwdriv€r,
then install the timing balsnce. b€lt driv€n pull6y.
FRONT BALANCER:
6 x 100 mm EOLT
REAN BALAI{CER SHAFT
t4 mm 12.9 inl