Steering Wheel - Honda Prelude 1993 Service Manual

Steering Wheel
- Removal
with sRs:
!@
store a removed driver's airbag
assembly with the pad surlace up, i{ lhe airbaq is
impropelly stored face down, accidental deploy-
ment could propel tho unit with enough lorc€ to
cause sedous injury.
CAUTION:
a Eefore removing the steering wheel, align the
front wheels straight ahead.
a Do not install used SRS parts Jrom anolher car.
When repairing, use only new SRS parts.
a Caretully inspecl the airbag ass€mbly belore in-
stalling. Do not install an airbag assembly that
shows signs of being dropped or imp.oparly
handled, such as dents, cracks or deformation.
a Always keep the shon connector(s) on the air-
bag(s) when the harness is disconnected.
a Do not disassemble or tamper with the airbag
assembly.
N O T E :
The radio may have a coded theft protection cir-
cuit. Be sure to get the customer's code number
betore
- Disconnecting the battery.
- R e m o v i n g t h e N o . 4 3 ( 1 O A ) t u s e l i n t h e u n d e r -
hood fuse/relay box).
- Removing the radao.
After service, reconnect power to the radio and
t u r n i t o n . W h e n t h e w o r d
" C O D E " i s d i s p l a y e d ,
enter the customer's s-digit code to restore radio
ooeration.
SRS MAIN HARNESS
1 7 - 8 1
a
Disconnect the negative and positive cable from
the battery.
Remove the access panel from the steering wheel
lower cover, then remove the short connector
( R E D ) .
Disconnect the connector between the airbag and
c a b l e r e e l .
Connect the short connector (RED) to the airbag
side ot the connector.
ACCESS PANEL
Remove the covers.
Remove the two TORXo T3O bit bolts, then
remove the driver's airbag assembly.
DRIVER'S AIREAG ASSEMBL
4 .
I
t
1..-\
& \
I\T
TORXO
R e p l a c e .
( c o n t a