Adiustment - Honda Prelude 1993 Service Manual

Mainshaft Thrust Shim
Check the thrust clearance in the manner described
below,
NOTE: Carry out the measuremsnt at normal room
temperature.
-1. Install the thrust shim selected and oil guide
plate in the transmission housing.
OIL GUIDE PLAYE
Adiustment (cont'd)
-2. Install the spring
ball bearing.
w a s h e r a n d w a s h e r o n t h e
NOTE:
. Clean the spring washer, washer and thrust shim
throughly before installation.
. l n s t a l l t h e s p r i n g w a s h e r . w a s h e r a n d t h r u s t
shim properly.
WASHER
g
aSttRrNGwasHER
Installthe mainshaft in the clutch housing.
Place the transmission housing over the main-
shaft and onto the clutch housing.
Tighten the clutch 8nd transmission housings
with several 8 mm and l0 mm bolts
Tap the mainshaft with a plastic hammer.
-4.
1 3 - 3 6
-7. Slide the mainshaft base over the mainshaft.
TRANSMISSION
-8, Attach the mainshaft holder to the mainshaft as
follows:
NOTE:
o B a c k - o u t t h e m a i n s h a f t h o l d e r b o l t a n d
loosen the two hex bolts.
. Fit the holder over the mainshaft so its liD is
towards the transmission.
. Align the mainshaft holder's lip around the
g r o o v e a t t h e i n s i d e o f t h e m a i n s h a f t
splines, then tighten the hex bolts.
MAINSHAFT HOLDER
EOLT
MAINSHAFT BASE
07GAJ - PG20130
-9. Seat the mainshaft fully by tapping its end with
a plastic hammer.
-10. Thread the mainshaft holder bolt in until it just
c o n t a c t s t h e w i d e s u r f a c e o f t h e m a i n s h a f t
Dase.
-1 1. Zero a dial gauge on the end of the mainshaft.
lla-F.
l:vli ffir"
MAINSHAFT
HOLDER
O?GAJ - PG2O11O
MAINSHAFT