Honda Prelude 1993 Service Manual page 641

Driveshafts
Installation (cont'd)
5. Install the damper fork over the driveshaJt and onto
the lower arm. Install the damper in the damper
tork so the aligning tab is aligned with the slot in
the damper fork.
6.
Loosely install the damper pinch bolt, and the new
damoer fork nut and bolt.
NOTE: The bolts and nut should be tightened with
the vehicle's weight on the damPer.
65 N.m 16.5 kg-m,47 lb-ft|
l.
t",i"tbtrf,+r" knuckle on the lower arm, then tighten
the castle nut and install new cotter pln.
CAUTION:
a 8e calotul not to damago tho ballioint boot.
a Torque the castle nut to the lowol torque
specitication, thon tightsn it only far snough to
align tho slot with ths pin hol€. Do not 8li9n tho
nut by loosening.
DAMPER PINCH BOLT
{SELF-LOCKING BOLTI
1 0 x 1 . 2 5 m m
44 N'm 14.4 kg-m, 32 lb-ft)
DAMPER FORK
TSELF-LOCKING
NUTI
1 2 x 1 . 2 5 m m
COTTER PIN
On reassembly,
bend the cotter pin
CASTLE NUT
14 x 2.0 mm
5 0 - 6 0 N ' m ( 5 0 - 6 . 0
36-43
tb-ftI
k9_m'
8. Tighten the new spindle nut
9, lnstsll the wheels with the wheel lug nuts.
NOTE: Before installing the wheel, clean the
mating surtace of the brake disc and inside of the
wheel.
FRONT WHEEL
SPINDLE NUT 24 x 1.5 mm
25o N.m 125 kg'm, 'l8l lb-ft}
NOTE: After tightening, use a dritl
to stake spindle nut shoulder
against the d veshatt.
Tighten the damper pinch bolt and the new damper
tork nut with the vehicle's weight on the damper.
ReJill the transmission with recommended oil or
tluid.
Check the tront wheel alignment and adjust if
necassary (see page 18-4).
WHEEL LUG NUT
1 2 x 1 . 5 m m
1 1 O N ' m
(11 kg-m,
80 tb-ft)
1 0 .
1 1 .
1 2 .
1 6 - 1 0