Honda Prelude 1993 Service Manual page 732

Steering Wheel
Installation (cont'd)
2ws/without SRS:
1. Install the steering wheel and tighten the steering
wheel nut.
NOTE: Align the slots on the steering wheel and
tabs on the turn signal cancelling sleeve.
2.
Install the emblem.
STEERING WHEEL
STEERING WHEEL
BLEM
STEERING WHEEL NUT
50 N.m
{5.O ks-m, 36 lb-ft|
EM
J
SIGNAL
17-86
ALIGNMENT MARK
ARROW MARK
4WS/With SRS:
CAUTION:
a The tront main steering angle sensor with the
neutral lock mechanism is mounted on the col-
umn shall ot the car. When the steering wheelis
removed, the rotation part oJ the sensor is lock-
ed at the electrically neutral position, and it is
unlock€d when the steeling wheel is inserted to
the specified installation position.
a lf the spoke angle is not at the designated angle
while driving straight, check the front and rear
wheels for proper alignment before adjusting the
spokg angle.
Pertorm the electronic n6utral check ot the 4WS
system to be sure that the rear wheels are at the
correct steedng angle while driving {see page
1 7 - 1 4 6 ) .
a B6fore installing the steering wheel. align the
f.ont whsels straight ahead.
a B€ su.e to install the harness wiles so that they
aie not pinched or interfering with other car
oarts.
a Do not replace the original steering wheel with
any other design, since it will make it impossible
to properly install the airbag. lOnly use genuine
HONDA replacement parts)
!@
confirm that the airbag assembly is
securely attached to the steedng wheel; otherwise,
sevore personal injury could tesult during later air-
bag dsployment.
1. Before installing the steering wheel, center the ca
ble reel.
Do this by first rotating the cable reel clockwise
until it stops.
Then rotate it counterclock w ise (approximatelv
two turns) until:
- The yellow gear tooth lines up with the align
ment mark on the cover.
The arrow mark on the cable reel label points
strarght uP.
i i .
f r .
l
CABLE REEL