Bleeding - Honda Prelude 1993 Service Manual

Bleeding
cAUTtOt{:
o Uso only clsan DOT 3 or 4 brake fluid,
a Mako suro no dirt 01 oth€l toreign mattor i5 allowod
to contaminate ths brake tluid.
a Do not mix diflorent brands of brako fluid as they
may not be compatible.
a Do not spill brake fluid on tho car; lt may damags the
paint; it brake tluid does contact the paint, wash it
ofl immadiately with wator.
FRONT:
NOTE: The reservoir on the master cvlinder must be
full at the stan ot bleeding procedure, and checked
after bleeding each brake caliper. Add fluid as required.
Use only clean DOT 3 or 4 brake fluid.
BLEEDING SEOUENCE:
REAR:
O Fronr Right O Roar Rlght
a Front Loft
a R..r L.fi
1 . Have someone slowly pump the brake pedal
several times, then apply steady pressure.
Loosen the brake bleed screw to allow air to escape
from the system. Then tighten the bleed screw
securelv.
3.
Repeat the procedure for each wheel in the se-
quence shown above, until air bubbles no longer
appear in the fluid,
4.
Check brake performance by road testing.
BI-EED SCREW
19-12