Honda Prelude 1993 Service Manual page 602

B .
24.
Connect the countershait soeed sensor connector.
Connect th€ starter motor cables.
NOTE:
When installing the starter cable, mak€ sur6 that the
crimped side ot the ring terminal is facing out (see
section 23).
COUI{TERSHAFT SPEED
SEITISOR CONNECTOR
lnstall the bsttery bsse and base stay.
Connect the ground cable to the body and the
transmission.
25.
26.
CABL€S
GROUND CABLE
BATTERY BASE STAY
I
14 -1 41
27. Install the intske control vacuum tank and intake
control vacuum tank brscket, then connect the
connecror.
28. lnstallthe air cleaner housing and intake air duct.
29. Refillthe transmission with ATF (see page 14-74.
30. Connect the battery positive (+) and negative (-)
cables to the battery.
31. Start the engine. Set the parking brake, and shitt the
trsnsmission through all gears three times. Check tor
proper shift cable sdjustment.
32. Check 8nd adjust the front wheel alignment (see
section 18).
33, Let the engine reach operating temperatur!_lthe
ralie-tor f8n com€s on) with the transmission in I N I or
I P I position, then turn it off and ch6ck tluid l8vel.
34. Road test as described on pages 1+68 thru 14-7O.
35, R8set ths radio stations.
36. Loosen the tront engine mount bracket botts after the
road test, and retighten them to specitied torque.
FRONT ENGINE
MOUNT ERACKET
BOLTS
1O x 1.25 mm
39 N.m (3.9 ks-m , 28 lb-ft)
FROl{f ENGINE
MOUiff