Honda Prelude 1993 Service Manual page 133

Timing Belt and Timing Balancer Belt
Replacement (cont'd)
6. Remove the cylinder head cover.
7. Remove the middle cover.
8. Remove the side engine mount.
9. Remove the dipstick and the pipe.
O-RING
Replace.
1 0 .
Remove the pulley bolt and the crankshaft pulley. Re-
move the two rear bolts Jrom the center beam to allow
the engine to drop down and give clearanceto remove
the lower cover,
Remove th€ rubber seal around the adiusting nut. Do
not loos€n the adjusting nut.
12. Remove the lower cover.
1 2 x 1 . 2 5 m m
6 x 1 . 0 m m
1 2 N . m ( 1 . 2 k g ' m ,
9 rb-ftt
12 x 1.25 mft
55 N.m (5.5 kg-r(,
40 tb-ft)
1 1 .
RUBBER SEALS
Replace when
oamageo ol
65 N.m {6.5 kg-m,
47 tb,ft)
RUBBER SEALS
Replace whsn
damaged or
deterio.ated.
RUBBER SEAL
Replace when
damaged or
det€aiorated.
MIDDLE COVER
Semove
o .
any
6 x 1 . 0 m m
12 N.m (1 .2 kg-m. 9 lb-ft)
PULLEY BOLT
1 4 x 1 . 2 5 m m
220 N.m (22.O kg-m, 159 lb-ft)
Apply engine oil to the
bolt threads, but not
to the surfac€ that
contacts the washer.
TIMII{G BELT
Inspoction, pago 6-60
Adiusting, page 6-60
CRAI{KSHAFT
PUI.LEY
ADJUSTIf{G NUT
10 r 1.25 mm
45 N.m {4.5 kg-m,
33lb-ft)
6 x 1 . O m m
1 2 N . m { 1 . 2 k g - m ,
9lb-ft)
6-64
Remove any oil.