Honda Prelude 1993 Service Manual page 455

1 0 .
Apply liquid gasket to the clutch housing mating
surface as shown.
NOTE:
.
Use liquid gasket (P/N 08718 - 0001).
. Remove the dirt oil fromthe sealing surface.
. Seal the entire circumference of the bolt hole to
prevent oil leakage.
.
lf 20 minutes have passed after applying liquid
g a s k e t , r e a p p l y i t a n d a s s e m b l e t h e h o u s i n g s
a n d a l l o w i t t o c u r e a t l e a s t 3 0 m i n u t e s a f t e r
assembly before filling transmission with oil.
Installthe 14 x 20 mm dowel pins.
Set the stopper ring as shown. Place the transmis-
sion housing over the clutch housing, being careful
to line up the shafts.
NOTE: Align the long arm of sth shift fork with the
hook on the stopper ring.
1 1 .
---: Liquid g6k.t
*: Dow6l pin
SNAP RING
1 3 .
1 4 .
12. Lower the transmission housing with the snap ring
p l i e r s a n d s e t t h e s n a p r i n g i n t h e g r o o v e o f t h e
countershaft bearing.
Check that the snap ring is securely seated in the
groove of the countershaft bearing.
Dimension A as installed: 3.60 -
6.32 mm
l0.i,r2 _ 0.249 inl
Install the 32 mm sealing bolt.
NOTE: Apply liquid gasket (PiN 08718 -
0001) to
the threads.
32 mm SEAI-ING BOLT
25 N.m 12.5 kg-m, 18lb-ftl
sNAp erN.:
{ c o n t ' d )
1 3 - 3 9