Honda Prelude 1993 Service Manual page 592

L
7 .
Install the main sepa.ator plate with three dowel pins
on the torque converter housing. Then install the oil
pump gears and oil pump driven gear shaft.
NOTE:
Install the oil pump driven gear with its grooved and
chamtered side facing down,
OIL PUMP DRIVEN
GEAR SHAFT
OII PUMP
DRIVEN
CHAMFER
GEAB
:/
)
OIL PUMP
DRIVEN GEAR
4 .
5.
\
\ rr-'rr
orl PUMP
\ 11 ll
DRIVE GEAR \ II II
|
\U GRoovE
Grooved €nd chamfer6d
aide fac€s separator plats.
Install the main vafue bodv whh tour bohs. Maks sure
the oil pump drive gear rotates smoothly in the normal
operating direction and oil pump driven gsar shaft
movss smoothly in the axial and normal operating
directions.
lf the oil pump drive gear and oil pump driven gear
shatt do not move treely, loosen the main valve body
bohs, realign the oil pump driven gear shatt, and th8n
retighten to the specified torque.
CAUTION:
Failuro to align tho oll pump drlvan goEr shaft
correctly wlll rosuh In a seizad oll pump drlva getl 01
oil pump driven gear shalt.
OIL PUMP ORIVEN
GEAR SHAFT
OIL PUMP
DRIVE GEAR
Installthe stator shaft and stoDDer shaft.
Install the two dowel pins, torque converter check
vafue and torque converter check valve spring in the
main valve body.
Install the.egulator valve body with the bolt on the
main valve body.
Install the two dowel pins and separator plate on the
regulator vatue body, then install the throttle vave
bodv with seven bohs.
8.
1 0 .
Install tho s€condary saparator plate with two dowol
pins on the main valve body.
Install th€ control shali in the housing with the control
shaft and msnualvafue together.
Installthe d€tent arm and alm shatt in the main valve
body, then hook the detent spring to tho detent arm.
SERVO SEPARATOR PLATE
SECO DARY VALVE BOOY
COIVTBOL SHAFT
DETEI{T SPRING
MANUAL VALVE
Installthe secondary vslve body, servo separator plate
and servo body with seven bohs.
Install th6 oil fosd pipe in tho servo body, then install
the 4th 8ccumulator cover whh three bohs.
Installth6 ATF strainer with two bohs.
Install the servo dotont base with two bohs and new
lock w8shers.
Inst8llthe lst/2nd sccumulstor body with six bohs.
Install two oil ts6d pipes in the main valv€ body and
th€ pipe in the servo body,
(conr'd)
1 1 .
't2.
1 2
14.
1 5 .
1 6 .
1 4 - 1 3 1