Honda Prelude 1993 Service Manual page 601

Transmission
SELF-LOCKING NUT
12 r 1 .25 mm
65 N.m {6.5 kem , 47 b-ft}
R6phco.
1 0 x 1 . 2 5 m m
39 N.m {3.9 ks-m .
28 b-ft)
lnstallation (cont'd)
1 4 .
1 5 .
Instsll new set rings on th€ end of th€ drivsshsfts'
Installthe right snd left driveshafts.
NOTE:
Turn the right 8nd lelt steering knuckles fully outward,
and axisllv into th€ difterential until you f8sl th€ set
ring engage th€ side gear.
lnstall ths damDer fork to the lower arm. Thsn instsll
the bslljoint to the lower arm. Use the castls nuts whh
new cotter olns.
t o .
COTTER PI
Replaca.
CASTLE IUT
l2 x 1 .25 mm
65 N.m 16.5 ks-m , 47 h-ft)
17. Install th€ rear beam stiff€ner 8nd center be8m.
CEI{TER BEAM
10 x 1 .25 mm
60 N.m {6.0 krm ,
43 tb-ft)
18. hstat the solash shield.
,t
14-140
19, Install the vehicle speed sensor/power steering speed
ssnsor and roar stiffoner. Conngcl the vehiclo spe6d
sensor connecror.
SPECIAL BOLT
6 x 1 . O m m
12 N'm (1.2 kgFm.9 b-ft)
10 x 1.25 mm
21 N'm (2.'l ks-m,
15 tb-ft)
POWER
STEERIl{G
SPEED
SE\lsqR
O-RING
R6pbc6.
REAR
n.
21.
22.
STIFFENER
1 O r 1 , 2 5 m m
39 N.m (3.9 ks-m , 28 lb-ft)
Connoct th€ ATF cooler hoses to the ioint pip6s.
Connect the lock-up control solenoid, shift control
solsnoid vslve connectors, 8nd the throttle control
cabls.
Connect ths msinshaft sp66d senaor connector.
SOLEM)ID VALVE
col{t{EcToRS
Install the ground
cable in step 26.