Back-Up Light Switch; Transmission Oil - Honda Prelude 1993 Service Manual

Maintenance
Transmission Oil
NOTE: Check the oil with the engine OFF, and the car on
level ground.
1. Remove the oil tiller plug, then check the level and
condition of the oil.
WASHEN
R e p l a c e .
Proper Level.
OIL FILI.IR PLUG
45 N.m (4.5 kg-m, 33 lb-ftl
2.
The oil level must be up to the fill hote. lf it is below
the hole, add oil until it runs out. then reinstall the
o i l f i l l e r p l u g .
3 . l f t h e t r a n s m i s s i o n o i l i s d i r t y , r e m o v e t h e d r a i n
p l u g a n d d r a i n t h e o i l .
4 . R e i n s t a l l t h e d r a i n p l u g w i t h a n e w w a s h e r , a n d
refill the transmission oil to the proper level.
NOTE: The drain plug washer should be replaced at
every oil change.
5. Reinstall the oil filler plug with a new washer.
Oil Capacity
1.9 / 12.0 US qt, 1.7 lmp qtl ar oil chango.
2.0 / {2.1 US qt, 1.8 lmp qtl at overhaul.
Use only SAE 10 W - 30 or 10 W - 40, SF or SG grade.
Back-up Light Switch
Replacement
NOTE: Check the switch see section 23.
1. Disconnect the back-up light switch wire connec-
rors.
2. Remove the back-up light switch,
3. Installthe new washer and back-up light switch,
OIL FILLER PLUG
'15 N.m (4.5 kg-m. 33 lb-ft)
WASHER
Feplace.
1 3 - 3