Steering Gearbox
Overhaul {cont'd)
62. After tightening the rack end, stske the four sec-
tions of lock washer with a dritt,
COMMERCIALLY AVAILABLE DRIFT
(Roll Pln Ddft, SnsPOn No. PPfi8l
NOTE: This drift has a tlat,
to prevent punctunng
the metal washer.
LOCK WASHER
Wood
block
1 . 0 - 1 . 3 m m
(0.04-O.05 inl
Check the lock wssher
diameter aft€r staking.
17-130
6 3 .
6 4 .
Apply grease to the circumlerence of the rack end.
Coat the tie-rod groove and inside oJ the boot with
silicone grease.
SILICONE GREASE
Cost the sliding
surface ot the rack
end.
GROOVE
lnstall the boots on the rack end with the tube
qamps.
NOTE: Check that the boot joint piece (i.e. air hose
ioint) is not clogged with grease.
-6,1
RACK END
6 5 .
I'
I
TUBE
CLAMP