Honda Prelude 1993 Service Manual page 941

Doors
Glass/Regulator Replacement (cont'd)
P66l th€ glass run channol out of the front chsnnel.
R€move the mounting bolts, then remove the front
channol 8nd center chsnnel.
NOTE:
After instslling, mak€ sur6 th€ ghss run chsnnol is not
twisted.
FROl{I
CHANNEL
OLASS RUN
MOU TII{G BOLTS
6 r 1 . O m m
I N.m (0.9 ks-m ,6.5 lb-ft)
NOTE:
To install. fit the glass run channel into the front and csnter
chann€ls as shown.
CEl{TER
CHA NEL
NOTE:
Apply tho adhssivo to th6
shadowod ar6s.
GLASS RUI{
CHANNEL
FROI{T
CHANNEL
Removo the two mounting bolts, two roll€r guide bolts
and loos€n the two mounting bolts. Disconnect the
conector. Remove th€ regulator through the center
hole in the door.
NOTE:
Scrib€ a line around the roller guide boh to show the
originsl adjustment,
ROLLER GUIDE BOLT
20-8
1 4 .
{ ' ! f i c a r f r -
BEGULATOB
MOU]TTING BOI-TS
8 r 1 , O m m
8 N.m (0.8 ks<n , 5.8 b-ftI
Loosen the bohs.
MOUNTING BOLTS
S x l . O m m
I N.m (0.8 ko-m . 5.8 lb-ft)
q
1 0 .
BOLLER
n
8 x 1 . 0 m m
I N.m {O.8 kg-m , 5.8 lb-ft)
Grease all th6 sliding surtaces oJ th6 regulator where
snown.
Before removing the powar window motor, mark tho
location by scribing I line across th6 s€ctor gear and
r€gulator.
Install using th6 motor mounting bohs. Move th€
regulator to tho originsl position by conecting I 12 V
battsry to tho power window motor {seo s6ction 23).
SECTON GEAR
POWER wlI{DOW
MOTOR
lnstEllEtion is thg rovorss of ths removal orocsdurs.
Roll the glass up and down to so6 il it moves frsev
without binding. Also make sur€ that there is no
clearance between the glass 8nd glass run channol
when the glass is closed. Adjust the position of th6
glass as necesssry (see page 2Ol0).
Attach the door hsrness to th6 door correctly (see
psgs 2G4).
When reinstalling the plastic cov€r, apply adhesive
8long the edge wh6r6 nocc€ssary to msintain a
continuous ssal and prevsnt watsr lgaks {see pag€ 2G
4t.
l l .
12.