Honda Prelude 1993 Service Manual page 594

22. Slip the r€verse idlsr gear into the transmisson housing
€s snown.
23. Align the spring pin of the control shaft with the
transmission housing g.oove by turning the control
shaft.
24. Install thr6€ dowel pins and a new gasket on thg
torqus converter housing,
25. Plscs ths transmission housing on the torque
convert€r housing.
1 0 r 1 2 5 m m
55 N'm (5.5 kg-m ,
40 b-ftt
DOWEL PI
P
h
E
CONTROL SHAFT
DOWEL PIN
1 4 - 1 3 3
m. hstall the trsnsmission housing bolts and t.ansmission
hanger, then torque the bolts to 55 N.m (5.5 kg-m, rlo
lb-ft) in two or more steps in the pattern shown.
27. Engage the reverse idler gear to the countershaft and
mainshatt reverse gesrs, then install the reverse idler
gesr shaft holder on the transmission housing,
6 x 1 . 0 m m
12 N.m (1.2 ks-m ,
I lb-ft)
28. Install the parking brske lever on the control shaft,
then torque the lock bolt loosely with a naw lock
wasner.
NOTE:
Do not tighten the lock boh to the specified torque and
bend the lock t8b in this steD.
,Adlafu
v|>=l
R@P