Honda Prelude 1993 Service Manual page 176

Timing Beft
lnspection
1 .
Disconnect the alternator terminal and the connector'
then remove the engine wire harnessfrom the cylinder
head cover.
2.
Remove the cylinder head cover
3.
Remove the middle cover.
4.
Inspect the timing belt for cracks and oil or coolant
soakang.
NOTE:
a Replace the belt if oil or coolant soaked.
. Remove any oil or solvent that gets onthe belt.
Inspect this
area for wear,
Rotate pulloy
and inspect belt.
After inspecting, retorquethe crankshaft pulley bolt to
220 N.m (22.O ks-m, 159 lb-ft).
.{d.,
Timing Balancer Belt
Inspection
1. Disconnect the alternator terminal and the connector,
then.emovethe engine wire harness fromthe cylinder
head cover.
2.
Remove the cylinder head cover
3.
Remove the middle cover.
4.
Remove the crankshaft pulley.
5. Remove the lower cover.
6.
Install the crankshaft pulleY.
7.
Inspect the timing belt for cracks and oil or coolant
soaking.
NOTE:
. Replace the belt if oil or coolant soaked.
a Remove any oil or solvent that gets on the belt.
Inspect this
area tor wear,
After inspecting, retolquethe ctankshaft pulley bolt to
220 N.m (22.O ks-m, 159 lb-ft).
NOTE: Reter to page 6-1 l3 for timing balancer belt
tension adiustment.
6 - 1 0 8