Honda Prelude 1993 Service Manual page 595

Transmission
Reassembly (cont'dl
29. Slio the sDecialtoolonto the mainshaft.
MAINSHAFT HOLDER
OTGAB-PF50100 ol
07GAB-PF50101
30.
2 1
Install the mainshaft idler gear.
Installthe old locknut on the mainshaft to seat the idler
gear.
NOTE:
. The mainshaft locknut has left-hand thresds,
. Do not drive the idler gear on with a hammer.
TOROUE: 230 N m (23.O ks-m, 166 lb-ft)
Install the secondary shaft idler gear on the secondsry
shaft.
Installthe thrust wash€r, thrust needle bearing, needle
bearing, countershatt idler gear and parking gear on
the countershatt.
Install the old locknut on the secondary shaft. Tighten
the old locknut to seat the secondary shaft idler ge81
while holding the countershsJt idler gear.
NOTE:
Do not drive the idler gear on with a hammer.
T O R O U E : 2 3 0 N m ( 2 3 . 0 k s - m , 1 6 6 l b - t t )
PARKII{G GEAR
SECONDARY SHAFT
IOLER GEAR
32.
33.
34.
14-134
35. Place a 24 mm socket on the parking geEr, and instsll a
10 x 1.25 mm boh in the count8rshaft. Then engage
the parking brake pawl with the parking gesr by
moving up the parking brake pawl.
CAUTlOltl:
K€ap an of tho particlos out of tho transmission whon
insialllng a bolt.
36. Tighten the boh and lightly seat the parkinggear.
NOTE:
Do not drive the parking gear on whh a hammer.
37. Remove the boh and socket.
38. Use the old locknut to tighten the press fit parking
gear to the specifled torque, then loosen it.
TOROUE: 230 N'm {23.O ks-m,166 lb-ft)
SOCKET.24 mm
PARI(ING GEAR
10 x 1 .25 mm
BOLT
PARKING BRAKE
PAWL
39. Remove th€ old locknuts, th8n install new conical
spring washers 8nd new locknuts on each shstt'
CAUTION:
Insts[ th€ conical spfng washora In tho di]octlon
shown,
MAINSHAFT LOCKNUT
Left-h8nd thr€ads
COUMTERSHAFT
LOCK'{UT
St€mp siJs
CONICAL SPRING
WASHERS
hstall in this
diroction.