Honda Prelude 1993 Service Manual page 777

66. Install the right and l€ft tie-rod 6nds.
TIE-ROO LOCKNUT
Final to.que: 45 N.m {4.5 kg-m, 33 lb-ft|
6 7 .
NE.ROD END
Grease a new O-ring and instsll it in ths groovs in
the rack guide sctew.
Coat the rack guide sliding surface with grease,.
Install the rack guide, spring and rack guide screw
on the gear housing.
RACK GUIDE SCREW
6 8 .
6 9 .
SPRING
LOCKNUT
GEAR HOUSII{G
GUIDE
Loosoly inslall.
( c o n t d
oTMAA-SLOO20A
70. Adiust the rack guide at the center of the rack
stroke.
71. Tighten the rack guide screw until it compresses
the spring and seats against the rack guide, then
loosen rt.
72. Retighten it to 4 N.m (O.4 kg-m, 2.9 lb-ft), back it
off about 20 + 5; then install the locknut on the rack
guide screw.
73. Tighten the locknut with the special tool to about
25 N.m (2.5 kg-m, 18 lb-ft) while holding the rack
guide screw.
LOCKNUT WRENCH,43 mm
RACK GUIDE SCREW
4WS:
74. Install the locknut on the front sub steering angle
sensor.
75. Grease a new O-ring and install it in the groove in
the front sub steering angle sensor. Install the rack
guide screw.
t*F