Crankshaft Oil Seal - Honda Prelude 1993 Service Manual

Crankshaft Oil Seal
; Installatio
I
|
.11
The seal surface on the block should be dry.
|
'E
Apply a light coat of oit to the crankshaft and to
the lip of the s6al.
l. Drive in crankshaft oil seal against right side cover.
NOTE: Drive the crankshaft oil seal in squarely.
DRIVER
07749 - 0or(xDo
DRIVEB ATTACHMCNT
079ir8 - SBlXtl01
C o n f i r m t h a t t h e c l e a r a n c e i s e q u a l a l l t h e w a y
around with a feeler gauge.
Cloarancc: 0.5 - 0.8 mm (0.02 - 0.03 inl
RIGHT SIDE
COVER
NOTE: Refer to pages 7-30 and 8-11 for installation
of the oil pump side crankshaft oil sear.
Pistons
lnstallation
B e f o r e i n s t a l l i n g t h e p i s t o n , a p p l y a c o a t o f
e n g i n e o i l t o t h e r i n g g r o o v e s a n d c y l i n d e r
bores.
1. ll the crankshaft is already installed:
. Set the crankshaft to BDC for each cvlinder.
o Remove the connecting rod caps and slip short
sections of rubber hose over the threaded ends
of the connecting rod bolts.
.
Install the ring compressor, check that the bear-
ing is securely in place, then position-the piston
in the cylinder and tap it in using the wooden
handle of a hammer.
a Stop after the ring compressor pops free and
check the connecting rod-to-crank journal align-
ment before pushing piston into place.
. Install the rod caps with bearings, and torque the
nuts to:
47 N.m {4.7 kg-m.34 lb-ft)
2.
lf the crankshaft is not installed:
.
Remove the rod caps and bearings, install the
nng compressor, then position the piston in the
cylinder and tap it in using the wooden handle of
a nammer.
. Position all pistons at toD dead center,
The arrow must tace the
timing belt side ot the
engine.
The mark muBt tace
the timing belt side
of the engine.
NOTE: Maintain downward force on the ring com-
p r e s s o r t o p r e v e n t r i n g s f r o m e x p a n d i n g b e t o r e
entering the cylinder bore,
Install seal with the
part number sid6
facing out.
0.5 - 0.8 mm
Use the wood€n handle
of a hammorto push, or