Honda Prelude 1993 Service Manual page 781

1 0 . Connect the four lines to the valve body unit, using
flare nut wrenches.
A: To oil cooler:
17 mm wrench
29 N.m (2.9 kg-m, 21 lb-ftl
B: To powgr stoedng speod sen3of:
12 mm wranch
13 N.m {1.3 kg-m, 9 lb-ft}
C: To rsseryoir: 12 mm wrench
1 3 N . m ( 1 . 3 k g - m , 9 l b - t t )
D: From pump:
14 mm wronch
38 N.m {3.8 kg-m, 28 lb-ft)
Reconnect the connector and secure the sensor
wire harness with the clamp and install the cover.
N O T E :
a -Be sure the sensor wire harness does not in-
terfere with the stabilizer or other moving parts.
a Be certain that the sensor wire harness is not
twisted betore connecting it.
Set the cover on the front sub steering angle sen-
sor. Secure the sensor wire harness and cover with
a new wire tie.
CONNECTOR
SENSOR WIRE
1 1 .
WIRE TIE CI-AMP
NOTE: After rack guide
electrical check on the
17-146],.
adjustment, perlorm the
4WS system (see page
SUB STEERING
1 4 .
Fill the reservoir with power steering fluid and bleod
air from the system by tufning the stesring whesl
from lock to lock several times with the engine
warm (see page 17-77l..
Make sure there afe no tluid leaks, then install the
gearbox shield,
Recheck the fluid level in the reservoir.
GEARBOX SHIELD
15. Install the center beam.
60 N'm
60 N'm
{6.0 kg-]n, 4.:l b-ft1
{cont d
{1.0 kg-m, 7 lb-ft}
1 7 - 1 3 5