Honda Prelude 1993 Service Manual page 793

5. Take out the service check connector (BLU 2P)
trom behind the center console. Connect the ter-
minals with a piece ot jumper wire.
NOTE:
a The 4WS indicator light will not indicate that
sensors are in the neutral position when display-
ing stored problem codes.
a Check and verify any problem codes displayed
before checking the neutral position.
SERVICE CHECK
CONNECTON IBLU 2P}
!1i
Pull up the parking brake lever fully and turn the ig-
nition switch on (engine off) to turn the parking
brske indicator light on. This sets the front sensors
in the insoection mode.
o -
JUMPER WIRE
Front sonsors insoection:
7. Check the front main steering angle sensor with the
ignition switch on (engine off),
- From the straight ahead driving position, turn
the steering wheel to the left, then turn the
steering wheel slowly to the right beyond the
straight ahead driving position. Do not turn the
steering wheel inversely.
- Turn the steering wheel to the left, then turn to
the right beyond the straight ahead driving posi-
tion. Repeat this operation several times until
vou tind the position where the 4WS indicator
light starts to come on steady.
4WS INDICATOR LIGHT
t
-Br
'
' 1 1 \
,r9 mm (t0.4 in/:!3of
-: --=- rll
!
F.om CENTER MARK
The 4WS indicator light should start to come on
within the range of i9 mm (1O,4 in/a3") from the
center mark on the steering wheel.
NOTE;
a The 4WS indicator light might look as if it is
blinking at a point near the ends of the specilied
range.
a To determine that the 4WS indicator light is oo
and not blinking, be sure that the 4WS indicator
light stays on for more than 2 seconds.
- Adjust the 4WS system if the indicator light
starts to come on at a ooint outside the mark-
ed range on the steering wheel (see page
1 7 - 1 5 1 l .
(cont'd)
17 - 14 7