Timing Balancer Belt; Tension Adjustment - Honda Prelude 1993 Service Manual

Timing Balancer Belt
Inspection
1. Disconnect the altemator terminal and the connector,
then remove the engine wire harnesstrom the cylinder
head cover.
2. Remove the cylinder head cover
3. Remove the upper cover.
4. Remove the crankshaft pulley.
5, Remove the lower cover,
6. Install the crankshaft pulley.
7. Inspect the timing balancer belt for c.acks and oil or
coolant soaking.
NOTE:
o Replace the belt if oil or coolant soaked.
a Remove any oil or solvent that gets on the belt.
Inspect this area tor wear.
Botate pulley
and rnspect belt.
After inspecting, retorque the crankshaft pulley bolt to
22O N'm (22.O ks-m, 159 tb-ftl.
NOTE: Refer to page 6-32 tor timing batancer belt
tension adjustment.
6-27