Honda Prelude 1993 Service Manual page 731

5, Install the driver's airbag assembly with new
TOBXo bolts.
DRIVER'S AIRBAG ASSEMBLY
TORX@ BOLT
lO N.m {'l.O kg-m, 7 lb-ft|
10 N.m 11.0 kg-m, 7 lb-ftl
6.
Disconnect the short connector (RED) from the air-
bag connector.
7, Connect the airbag connector and cable reel
connector.
8.
Attach the short connector {BED) to the access
panel, and install the access panel on the steering
lower cover.
CAELE REEL
CONNECTOR
TORX@ BOLT
SHORT CONNECTOR
1 7 - 8 5
9. Connect the battery positive terminal and then
connect the negative terminal.
'10. After installing the driver's airbag assembly, con
firm proper system operation:
a Turn the ignition to ll position: the instrument
p a n e l S R S i n d i c a t o r l i g h t s h o u l d c o m e o n f o r
about six seconds and then go off.
a Confirm operation of horn buttons.
a Confirm operation of cruise control set/resume
S\/!r'rrcns.
a Turn the steering wheel counterclockwise and
m a k e s u r e t h e y e l l o w g e a r t o o t h s t i l l I i n e s u p
with the alignment mark.
YELLOW GEAR TOOTH