Honda Prelude 1993 Service Manual page 802

Hide thumbs Also See for Prelude 1993:

Table of Contents

4WS System Adjustment

Sub Steering Angle Sensor Adjustment lcont'dl

Remove the fear steering actuator cover

Remove the cap bolt and sealing washer from the

rear steering actuator. Sc.ew the special tool in as

far as it will go.

SEALIT{G WASHER

REAi STEERING CENTER LOCK PIN

07NAJ-SSOO20A

7. Remove the rear sub steering angle sensor wire

from the clamp and disconnect the connector'

Loosen the locknut. Tighten the locknut tully by

hand, then bsck it oft about

'l12 turn and connect

the connector'

9. Set the steering wheel in the strsight ahead driving

position to prevent the rear wheels trom steering if

the engine is started in error.

1O. Turn the ignition switch on (engine otf).

11. Push the rear left wheel tully to the left by hand,

then push it slowly to the right to turn the 4WS in-

dicator light on (i.e. .ear main stee.ing angle sensor

is electronicallv in neutral).

REAR LEFT WHEEL

a The 4WS indicator light turns on in a natrow

range. Do not ovetlook it.

a Work with ca.e so as not to move the real

wheels from this neuttal position.

Troubleshooting