Honda Prelude 1993 Service Manual page 638

Reassembly
Clean the driveshatts before reassemblv.
Wrap the splines with vinyl tape to prevent damage
to the boots and dynamic damper (A/T models, l€tt
driveshaft only).
Install the outboard boot, dynamic damper and in-
board boot to the driveshaft, then remove the vinyl
I A D E .
OUTBOARO BOOT
VIf{YL TAPE
DYNAMIC DAMPER
lA/T modob,
loft ddvGhaft onlvl
4 .
INBOARD BOOT
Install the stopper ring into the driveshaft groove,
Rotate the stopper ring in its groove to be sure it is
fully seated.
Install the spider on the driveshaft by aligning the
marks on the spider and end of the driveshaft.
Fit the circlip into the driveshaft groove. Rotate the
circlip in its groove to be sure it is fully seated,
SPIDER
STOPPER RING
CIRCLIP
b
"""@
6.
Pack the outboard joint with the joint gr€ase
cluded in the new driveshaft set.
crease Ouantity. 130-140 9 (4.6-4.9 ozl
Fit the rollers to the spider with their high shoulders
facing outward.
CAUTION:
a Rainstall tho rollor3 in their o ginal posilions on
the sDidel.
a To prsv€nt it from talling off, hold tho drlveshatt
assembly so th€ spidor and lollor point up.
1 S 7