Honda Prelude 1993 Service Manual page 627

Differential (Automatic Transmissionl
Reassembly
'1. Install the side gears, with thrust washers in tho dif-
ferential carrier.
NOTE: Coat all gears with molybdenum disulfide
grease on all sides.
Set the pinion gears in the place exactly opposite
each other in mesh with side gears, then install a
pinion washer behind each one. Wsshers must be
of equalthickness.
NOTE: Select the correct Dinion washer from the
table on page 15-14.
1 5 - 1 6
THRUST WASHER
Align the holes.
Rotate the gears until the shaft holes in the pinion
gears Iine up with the shaft holes in carrier.
Insert the pinion shaft and align the spring pin holes
in one end with the matching hole in the carrier.
5.
Drive in the spring pin with a pin punch.
Check backlash of both pinion gears again.
Standard {New}: 0.05 - 0.15 mm
{0.lxt2 - 0.006 in}
It still out of tolerance, replac€ both thrust wash-
ers.
lf still out of tolerance. replace the side and pin-
ion gears, and recheck backlash.
lf still out of tolerance, replace the carrier assem-
ory.