Honda Prelude 1993 Service Manual page 607

Hide thumbs Also See for Prelude 1993:

Table of Contents

. All SRS oloctlical wirlng harno3sos alo covorod whh

ydbw ouier insulation.

. Befolo disconnecling tho SRS who harn6ss, lnllall tho

short connoctor (s) on tho ai6ag (s).

. Replscs the sr iro 8fiect6d SRs halno$ Esrembly lf h

has an open circuit or damag€d wiring.

Stan the engine. Shift to reverse to see il the reverse

gear engages. lf not, reJer to Troubleshooting on page

1+64 thru 67.

With the engine off, remove the tront console (sae

section 20).

Snit to I tt l position, then remove ths lock pin from

the cable-adjuster,

7 N'm lO.7 kg-m

Check that the hole in the adiuster is pertectv sligned

with the hole in the shift cable.

There are two holes in the end of the shift cable. They

are Dositionad 9Oo apart to allow cable adiustments in

1/4turn increments.

lf not pertectly alignod, loosen the locknut on the shift

cable, and sdiust as required.

Tighten the locknut.

Installtho lock pin on the adiuster. lf you tesl the lock

pin binding as you reinstall it, the cable is still out of

adjustment and must be readiusted.

Move the shift lever to each gear and verify that the

A/T gear position indicator follows the A/T gear

position switch.

Start the engine and check the shift lever in allgears. lf

any gear does not work properV, reler to trouble-

shooting on page 14-64 thtu 67,

Insert the ignition k€y into the key cylinder on the A/T

g€ar indicatot panel, 8nd verify that the shift lock lever

is released.

Troubleshooting