Honda Prelude 1993 Service Manual page 545

20. R€move the center beam 8nd r6ar beam stifJener.
22
Romovs ths cott€r pins and castls nuts, thsn sep8r8t6
the ball ioints from the low6r arm (see section 18),
Remove the damper tork bohs. then separste tha
damper tork and lower arm.
21.
r
SELF.LOCKING
UT
Roploco.
rY
P6*ii53., cAsrLENur
B .
24.
Pry the driv€shafts out ot ths differentisl.
Pull on the inboard joint and remove the right and left
driv€shafts (s€6 ssction 16).
Tie plastic bags ov6r the driv€sh8ft enos.
NOTE:
Coat 8ll precision finished 9urf8c6s with clean ongine
oilor groass.
DRIVESHAFT E D
26. Remove the right dsmpsr pinch boh, then separate tho
damoer fork and dsmoor,
27. Remove the self-locking bolts and self-locking nut,
then romove ths right radius rod.
DAMPER FORK
SELF.LOCKIIIG NUT
ReDhco.
DAMPER PII{CH
EOLT
R6plac€.
sELF-L(rcKhIG
BOLT
R6place,
(cont'd)
RADIUS ROD
14-83