Honda Prelude 1993 Service Manual page 113

Cylinder Head
Removal (cont'd)
7.
Remove the tuel feed hose, the tuel return hose and
the brake booster vacuum hose.
FUEL FEED HOSE
WASHER
Replace.
Remove the lollowing engine wire hsrness connec-
tors and clamps ftom the cylind€r head and the in-
take manifold:
o Four fuel injector connectors
a lntake air temDerature (lAT) sensor connector
a ldle air control (lACl valve connector
a Throttle position (TP) sensor connector
a Exhaust g8s recirculstion (EGR) valve lift sensor
connecror
a Ground cable terminals
a Engine coolant temperature (ECT) switch B con-
necror
o Heated oxygen sensor (HO2S) connectot
a ECT sensor connector
a ECT gauge sending unit connector
a lgnition control module llCMl connector
a CKP/ToC/CYP sensor connector
a Vehicle sDeed sensor (VSS) connector
a lgnition coil connector
a Intake air bypass solenoid valve connsctor
a ECT switch A connector
a Knock sensor connector
6-44
9.
R€move th€ engine ground cable Jtom th€ cylinder
head cover.
10, Disconnect the alternator terminal and connector,
then remove the engine wire harness from tho
cvlindsr head cover.
EI{GINE WIRE
HARNESS
8 t{.m (0.8 kg-m, 6 lb-ftl
6 x l . O r r | m
10 'm (1.0 kg-m, 7 lb-ftl
11. Removo the powsr steering lP/S) pump belt and
pump.
a Do not disconnect the P/S hosos.
6 r
8 x 1.25 mm
22 .|n (2.2 kg-m,
16 tb-ft1
15 N.m ll.5 *g-m,
I I lb-ftl