Rear Window
Installation (cont'd)
13. Us€ suction cups to hold the reat window over the
oponing,align it with the alignment marks made in step
7 and s€t it down on the adhesiv€. Lightty push on the
raar window until its edges are fully sested on the
sdhosive allthe waV around.
NOTE:
I Do not close or open the doots until adhesive is dry.
. Mske sure the fasteners are Jastened correctly'
ALIGNMENT MARKS
REAR
wtt{oow
Scrape or wipe excess adhesive otf with a puttY knile
or tow€|.
NOTE:
To remove adhesive from I painted surfsce or the rear
window, use a sott shop toweldampsned with alcohol'
lnstsllthe rear window molding.
NOTE:
. When installing, make sure thsre are no twists in the
rear window molding.
. First instalt the upper section, th€n install the each
side.
. Glue the upper section with the adhesive'
1 4 .
t a .
REAR WII{DOW
MOLDNI{G
CUPS
20-24
16, Installthe molding holder on the low€r molding.
1 7 . lnstsll the
screws,
lower moHing, then tighten the mounting
18. Let th€ adhosive dry for at lesst one hour, then sprsy
wate. ovst the tear window 8nd check for leaks M€rk
l€8king areas and let the rear window dry, than seal
with s68l8nt.
NOTE:
Let the csr stsnd for 8t least fout houts after l€ar
;indow installation ff the cat has to be used whhin
the first four hours, it must be driven slowv
19. Rssssomble 8ll removed Parts.
l1