Honda Prelude 1993 Service Manual page 574

lnstallation
NOTE:
Lubricate all parts with ATF during Essembv.
1, Instslltwo new O-rings on the countershaft,
NOTE;
Before installing the O-ring6, wrap ths shaft splines
with tape to prsvent dsmags to the O-rings.
2. Assembls the 1st-hold clutch assembly, lst gear collar,
thrust washer, needl€ bearing, lst gaar, one-way
clutch, thrust needle bearing and 3rd gear.
3RD GEAR
THRUST '{EEDLE
BEARIl{G
O]TE-WAY CLUTCH
lnstall in this direction.
lST GEAR
I{EEDLE BEARING
THRUST WASHER
lST GEAN COLLAR
1ST-HOLD CLUYCH
ASAEMBLY
3. Installth8 above assemblv on the countershaft.
4.
Align the shaft splin€s with thoso of 3rd gaar, then
press the countershaft into 3rd gear with a press.
NOTE:
. Also align the shaft splines with those of th€ lst-
hoH clutch when pressing the countershaft into the
3rd gear.
. Use 8n attachment between the shaft and a press
to provant damage to the countershatt.
. Stop pressing the countershaJt when the 1st-hold
clutch contacts the finaldrive gear.
1ST-HOLD CLUTCH
PRESS
1 4 - 1 1 3