Honda Prelude 1993 Service Manual page 421

6. Disconnect the starter motor cables, then remove
the starter motor.
7. Disconnect the back-up light switch connectors and
transmission ground cable.
8. Remove the wire harness clamp.
WIRE
BACK.UP LIGHT SWITCH
HARNESS
STARTEB
MOTOR
STARTER
MOTOR
CABLES
9 .
1 0 .
TRANSMISSION
GROUND CABI.T
Shift the transmission into reverse.
First remove the cable bracket, then disconnect the
cables from the top housing of the transmission.
NOTE: Remove both cables and the bracket togeth-
er.
CAUTION: Take crre not to bond ths cables.
Do not aamovo.
'}{FT CAALE
STEEL
PLASTIC
WASHER I WASHER
Inspect for
wear and
oamage.
WASI{EB
a n d
WASHER
Inspect for
Replace.
1 3 - 5
1 1 .Disconnect the vehicle speed sensor (VSS) connec-
tor and remove the VSS/power steering speed sen-
sor, but leave its hoses connected.
vss coNNEc?oR
POWER
STEERING
SPEED
SENSOR
O-RING
Replace.
12. Remove the slave cylinder.
NOTE:
. Do not operate the clutch pedal once the slave
cylinder has been removed.
. Take care not to bend the clutch pipe.
(cont'd)
CLUTCH HOSE
SLAVE CYLINDEB