Sunroof Seal Repair - Honda Prelude 1993 Service Manual

I N'm (0.9 ksFm ,6.5 h-tt)
5. Rsmove the mounting nuts from the panel brackats on
both sides, then rernove the sunroof panel by lifting up.
NOTE:
Do not damage the roof panel.
SUNROOF PANEL
lnstallation is the reverse of the removal procedure.
NOTE;
. Before installing the sunroof liner, close the sunrool
panel fully, then check fo. closing slignment, lf
necessary, adjust the sunroot panel alignment {see
page 2G3Ol.
o When inst€lling the sunroof linar, make sure the
sunroot liner is fast€ned correctly with the clips and
holder.
Check tor water leaks.
NOTE:
Do not us€ high pressur€ water,
Sunroof Seal Repair
ff a sunroof seal is leaking, or if it is to be replaced, proceod
as follows:
1. Remove the sunroof liner (see page 2G30).
2.
Remove the sunroof panel.
3. Remove the seal holder, Carefully peelthe sealoff the
sunroof panel.
> : Scrow, nut locttlon!
r ' 9
c
t, 6
c , A
SU R(X)F SEAL
Fillwirh adhesive.
SUNROOF PANEL
4.
Clean the sunroof seal attaching surfaces with a clean
cloth dampened in alcohol.
NOTE:
After cleaning, keep oil, grease or wster from getting
on the surface.
5.
Fill the sunroot seal groove with adhesive. Coat the
sunroof seal att€ching surfaces of the sunrool panel
with the sam€ adhesive.
6.
Fit the sunroot seal onto the sunrool panel evenly all
the way around.
7. Wlpe off excess sdhesive with a clean cloth
dampened with alcohol.
8.
Allow the sdhesive to cure tor st least four hours atter
sunroot seal installation 8nd before operating the
sunroof panel.
9. Check for water leaks.
NOTE:
Do not use high pressure water.
SUNROOF
SEAL
o .
20-31